AudioControl ACR-1 Dash Remote for LC2i / LC6i / LC7i / Matrix Plus / Overdrive Plus / 6XS / The Epicenter / LC-4.800 / LC-6.1200

AudioControl ACR-1 Dash Remote for LC2i / LC6i / LC7i / Matrix Plus / Overdrive Plus / 6XS / The Epicenter / LC-4.800 / LC-6.1200

Add remote level control for your AudioControl processor or amplifier. This is the replacement remote for the Epicenter. Comes with a 20 foot cable and removable mounting enclosure (for custom dash installations).

Compatible with

• LC2i
• LC6i
• LC7i
• LC-4.800
• LC-6.1200
• Overdrive Plus
• Matrix Plus
• 6XS
• The Epicenter®

Legacy products supported:

• LC6
• LC8
• Original Epicenter® (bypass not supported)

All install methods at a glance

• Placement And Mounting of Optional Dash Remote

  The dash control may be mounted under the dash using its own bracket or through a custom hole in the dash. It should be within reach of the driver and in a spot where the LED is plainly visible.

• Bracket Installation

  The dash control mounts with two screws, which attach to the underside of the dashboard. Slide under the dash and place the dash control in its mounting position, mark the two mounting holes, drill pilot holes, and secure with two screws.

• Custom Installation

  For that custom, finished look, the dash control can be flush mounted directly on the dash-board (or anywhere else). Referencing the drawing right, disassemble the dash control from the mounting bracket. Drill a 9/32” (7 mm) hole in the dashboard for the control along with a 3/32” (2.3 mm) hole for the lock tab and a 1/8” (3 mm) hole(s) for the LED holder. Reassemble the dash control components on the dashboard.