Axxess AXUTR universal Trigger Output Module

Axxess AXUTR universal Trigger Output Module

The AXUTR is a universal trigger output module with different programmable functions combined in one product. When triggered, the AX-MTR can be pulsed, latched or timed switch the outputs. The programmable functions are stored in nonvolatile memory.

All features at a glance:

1. Low-voltage release

• provides 12V for aftermarket amplifiers available or converts a 5V source to a 12V Ausgangum, eg for Ford Radios

2. Alpine Freeview

• enables video playback while driving

3. Latched output by pulsed input

• switch from headlights or radio via switch

4. Double pulse output:

• Pulses are output twice when a constant or pulsed signal is triggered, for example for alarm applications in which two pulses are required to unlock all the doors

5. Closed-loop circuit

• Monitoring / (retrofit) alarm condition occurs when a trailer is separated from the trailer hitch;
• also monitored stereos

6. Pulse stretching / Delayed shutdown

• at constant or pulsed trigger AX MTR switches the outputs an example for conveniently switching on the headlights at night;
• raised alarm duration of 1s to 3s for Mercedes vacuum door locks

7. horn alarm setting

• in older retrofit alarm systems, it is difficult to eliminate the current alarm by remote control: by a 2s delay between tones disabling is easier;
• allows unique alarm horn: Program 1-5 Hup tones

8. A linear actuator controller

• Open & Close of amp racks, for example, with negative alarm output

9. Door lock pulse

• for automatic locking & unlocking door locks, with ignition on / off

10 channel splitter:

• notify an alarm Channel 2 outputs, both are programmable

11 pulses for constant power:

• counts pulses via a programmable period and on an output

12. 3 timer in 1 module

• All 3 outputs can be activated with delay or can be deactivated immediately activated and delayed

13 pulses for latched outputs

• programmable number of pulses to activate each output and to disable, for example, to switch from retrofit light with parking light switch

14 pulses for pulse output

• after a certain number of pulses within a programmable time pulse outputs, ie: you program 4 pulses in this period of 5s and these 4 carried out in this period as pulsing the output 1x

15 pulses for the temporary intervention

• at a certain number of pulses within 5s, the outputs are enabled and delayed by the programmed time again

16. Latch Output # 2

• eg for switching from 2-light with a switch:
  1. Pulse: Output activated 1,
  2. Pulse: disabled Output 1 + activates output 2,
  3. Pulse: activate outputs 1 + 2
  4. Pulse: disabled outputs 1 + 2