Customer Hotline
+49 (0)351 871 8222
Filter
Hertz
-
Hertz ML 280.3 35mm Tweeter 180W Max. 4 Ohm, 1kHz - 28kHz - Mille- 35mm Tetolon Fiber dome Tweeter optimized with FEA simulations
- Max.: 180W
- Impedance: 4 Ohm
- Frequency: 1 kHz - 28 kHz
- 28mm ferrofluid-cooled mobile voice coil
- Rear chamber sized for only 900 Hz Fs
- High-density damping material underneath the dome & low-density absorbing material in the rear chamber
- Extremely pure copper short circuit ring
- Neodymium magnet optimized with FEA simulations of the magnetic flux for utmost control and fast response to the transients
€259.00Incl. 19% VAT , excl. Shipping Cost
Free Shipping in GermanyA20881Delivery Time 11 - 14 Days* - 35mm Tetolon Fiber dome Tweeter optimized with FEA simulations
-
Hertz MP 25.3 29mm Tweeter 120W Max. 4 Ohm, 1,4kHz - 22,5kHz - Mille- 29mm Tetolon fiber soft dome Tweeter with “Center Tuning Duct” geometry
- Max.: 120W
- Impedance: 4 Ohm
- Frequency: 1,4 kHz - 22,5 kHz
- 25mm ferrofluid-cooled mobile voice coil
- Rear chamber filled with selected damping material and sized for lower Fs
- Faceplate geometry optimized with FEM (Finite Element Modeling) technique for a linear frequency response in off-axis installations
- Inclusive accessories for surface and recessed mounting
- Neodymium Magnet with high-density magnetic flux, optimized for maximum control during high-energy dynamic transients in the mid-high frequency range
99,00 €Incl. 19% VAT , excl. Shipping CostDelivery 6,49 € in GermanyA20880Delivery Time 11 - 14 Days* - 29mm Tetolon fiber soft dome Tweeter with “Center Tuning Duct” geometry
-
Hertz MPCX 2 TM.3 PRO passive crossover for MP 70.3 / MP 25.3 with MP 165.3 / MP 165P.3- Passive crossover specifically developed for MP 70.3 and MP 25.3 when installed in a 3-way multi-amplification system and combined with an MP 165.3/ MP 165P.3 woofer actively driven
- Two-position (0 / +2 dB) switch for tweeter level adjustments, to fine-tune the transducers emission
- 160V extremely high quality bi-metallized polyester film capacitors with ultra-low DF, for maximum sound transparency and neat mid/hi-frequencies
- 1mm pure copper wire low series resistance inductors, for low dissipation losses in the mid-range section where high transient currents are demanded
- Small footprint design for easy installation, with top vent grille for efficient heat dissipation
€49.00Incl. 19% VAT , excl. Shipping CostDelivery 6,49 € in GermanyA21403Delivery Time 11 - 14 Days*
